1. Blockage
The tail shell is covered with raw materials, causing the belt to deviate or become inoperable.
Reason: 1) Early feeding and late starting of the hoist; 2) The belt lacks sufficient support and runs off course, and the belt is not loose or tight enough; 3) Excessive feeding; 4) Block shaped raw materials fell into the motor shaft, causing the material bin to get stuck. 5) Too much material was returned and blocked.
Ways to avoid elevator blockage: 1) Strictly follow the driving and parking procedures; 2) Adjust the tensioning equipment to ensure the necessary support force for the traction rope; 3) The feeding amount of the elevator is moderate, stable and even.
2. Return of materials
During the entire unloading process, raw materials that have not left the silo or have left the silo but have not entered the unloading pipe. If there is less material return from the elevator, it will result in a decrease in transportation efficiency and blockage of the base.
Reason for material return: 1) The fitness exercise speed of the silo is not appropriate or does not comply with the unloading method, such as excessive speed during filtration and unloading. Unloading too early, the reflective surface enters the base; When unloading with force, the speed is too slow, the unloading is too late, and it falls into the base; 2) The appearance of the shell is not scientific or does not comply with the unloading method; 3) Inlet blockage; 4) The interval between buckets is not suitable; 5) There is a large gap between the unloading partition and the lifting bucket, and the unloading partition is severely damaged. During unloading, some of it returns to the lifting bucket for back and forth.
Solution: 1) Adjust the speed ratio of the hoist and replace the dustbin; 2) Replace the engine casing; 3) Clear the feeding port and ensure that the feeding port is unobstructed; 4) Adjust the spacing of the dustpan again; 5) Adjust the height to width ratio of the unloading partition or replace it.
3. Belt direction deviation
Reason for directional deviation: 1) There is no horizontal line in the management center of the head or bottom wheel; 2) The belt connection head is skewed; 3) The uneven level of damage on both sides during the entire operation of the belt results in inconsistent tightness on both sides; 4) Uneven damage to the rubber cover of the head wheel; 5) The head wheel axle does not have a horizontal line; 6) The front and rear wheels are no longer on the same straight line.
Solution: 1) Adjust the flatness of the scraper again and adjust the management center of the front and rear wheels; 2) Reconnect the belt; 3) Check the feeding method; 4) Remove and replace the rubber cover of the head wheel; 5) Adjust the level of the head wheel and adjust the height of the seat bearing; 6) Correct the casing of the elevator again to determine if it is vertical, and adjust the level of the head wheel before adjusting the tail wheel.
