Common rice husker equipment includes rubber roller rice husker, sand disk rice husker and centrifugal rice husker.
Rubber roller rice husker
The main working parts of the rubber roller rice husker are a pair of horizontal rubber rollers or plastic rollers bonded or covered with rubber layers on cast iron cylinders. The axes of the two rollers are located in the same horizontal plane or have a slight height difference. They rotate in opposite directions at different speeds. One roller is fixed and the other roller can be moved, so that the rolling distance between the two rollers can be adjusted. The difference in linear speed between the two rollers is 2 to 3.2 m/s, and the sum of the linear speeds should not exceed 30 m/s. The rice is fed evenly between the two rollers along the entire length of the rubber roller through the flow plate (or through the feed roller and the flow plate). The equal-diameter rollers rotate in the opposite direction at different linear speeds, and the rice passing through the rollers is squeezed and torn by the pressure of the pressure roller. Due to the squeezing of the two rollers and the tearing effect caused by the speed difference between the two rollers, most of the rice is husked and enters the rice husk separation device, and then the rice husk is sucked out of the suction port at a wind speed of 4 to 5 meters per second. After the rice-rough mixture is separated from the rice husk, the rice-rough mixture is discharged from the discharge plate. There are two types of rolling distance adjustment mechanisms: fixed pressure adjustment and fixed distance adjustment. Fixed pressure adjustment can be carried out by air pressure, hydraulic pressure or thallium pressure. Among them, the thallium pressure type automatic tight roller (rolling distance adjustment) mechanism was first developed in China in the 1960s. In order to keep the linear speed difference of the two rubber rollers correct, China has also developed a transmission method combining a gearbox and a triangular belt. The rubber roller rice husking machine has a high husking rate, a smooth brown rice surface, and less broken rice, but when the temperature is high, the rubber roller wears quickly, the brown rice is more likely to burst, and the production cost is high.
Sand disk rice huller
The sand disk rice huller uses two circular diamond sand disks, the upper disk is fixed, and the lower disk rotates, with a linear speed of 20 to 25 m/s. The rice is husked in the two sand disks due to the end pressure and tearing. The advantages are less cracking of brown rice, the sand disk is more wear-resistant than the rubber roller, and the processing cost is low; the disadvantages are low husking rate and more broken rice. The main working parts of the sand disk rice huller are annular diamond sand disks bonded to the cast iron disc. The upper and lower disks are fixed, and the lower disk rotates and can move up and down. The gap (rolling distance) between the upper and lower sand disks is adjusted according to the size of the rice grains. The rolling distance should be less than the length of the rice, but greater than the width and thickness of the rice. The rice is fed from the feeding hopper to the lower sand disk through the central area of the upper sand disk. The centrifugal force generated by the rotation of the lower sand disk forces the grains to enter the annular husking area between the two disks. Under the end pressure and friction, about 75% of the rice can be husked, but there are more brown and broken rice. After husking, the rice-rough mixture is discharged from the machine after the husk is removed by airflow through the husk separation device. The outer diameter of the sand plate is 400-1120 mm, and the width of the annular husking area is generally the outer diameter.
Centrifugal rice husker
The main working parts of the centrifugal rice husker are the rotating throwing plate inside and the fixed impact circle outside. The rice enters the working area and is accelerated by the throwing plate, and flies to the impact circle with the help of centrifugal inertia, and is husked due to impact. This machine has a simple structure, convenient operation and management, low power consumption, and low processing cost; but there is more broken rice and the rice output rate is low.
